make sure that your nipper is sharp. its hard to avoid stress marks if you are only using nippers to cut parts from runners and clean the excess sprue. use a hobby knife to cut away excess sprue to get best result. just watch out not to overcut it.
how was your build? i was also working on this kit last week. messed up the decals beam shields. just a heads up (if you haven’t done it yet) you are supposed to put the decals on the backside of the beam shield. 😀
what they said^ and you can also use a black Gundam Marker (used for panel lining) and just put some of that on the white stress mark, give it a few seconds to sink in, then while it off by rubbing with your thumb. Should get rid of the white ^^
Well ur best best would be cutting closer to the runner then sand down to the actual part. It has worked for me.
make sure that your nipper is sharp. its hard to avoid stress marks if you are only using nippers to cut parts from runners and clean the excess sprue. use a hobby knife to cut away excess sprue to get best result. just watch out not to overcut it.
how was your build? i was also working on this kit last week. messed up the decals beam shields. just a heads up (if you haven’t done it yet) you are supposed to put the decals on the backside of the beam shield. 😀
what they said^ and you can also use a black Gundam Marker (used for panel lining) and just put some of that on the white stress mark, give it a few seconds to sink in, then while it off by rubbing with your thumb. Should get rid of the white ^^